Supermicro SuperStorage SSG-6049SP-DE1CR60 User Manual page 96

Table of Contents

SuperStorage Server SSG-6049SP-DE1CR60/90 User's Manual

SATA Port 0~ Port 3

Hot Plug (SATA Port 0~ Port 3)

Select Enable to support Hot-plugging for the device installed on a selected SATA port

which will allow the user to replace the device installed in the slot without shutting down

the system. The options are Enable and Disable.

Spin Up Device (SATA Port 0~ Port 3)

Select Enable for Staggered Spin Up support which will allow the SATA devices specified

by the user to spin up one at a time during system boot in an effort to prevent all hard

drive disks from spinning up at the same time, causing a power surge. The options are

Enable and Disable.

SATA Device Type (SATA Port 0~ Port 3)

Use this feature to specify if the device installed on the SATA port specified by the user

should be connected to a Solid State drive or a Hard Disk Drive. The options are Hard

Disk Drive and Solid State Drive.

*If the feature, Configure SATA as, is set to RAID, the following features will become

available for user's configuration:

SATA RSTe Boot Info (Available when Configure SATA as is set to RAID)

Select Enable for full int13h support which will allow the system to boot using a device attached

to the SATA controller. The options are Disable and Enable.

SATA RAID Option ROM/UEFI Driver (Available when Configure SATA as is set to

RAID)

Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for

system boot. The options are Disable, EFI, and Legacy.