Module Programming; For Convenience-Only Programming, See Next Section - Directed DB3 Installation Manual

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.
For Convenience-Only programming, see next section.
Ensure vehicle is in a safe location and cannot move forward during programming. For
1
vehicles equipped with a manual transmission, make sure the gearshift lever is in the neutral
position.
The harnesses must be connected in this exact order:
1. Connect the 14-pin.
2
2. Connect the 12-pin.
Connect the 10-pin.
3.
When the LED turns on solid red, proceed with the next step.
Press the Push-to-Start (PTS) button twice (2x) to turn the ignition ON.
1.
3
The LED will start to flash orange quickly, then green quickly.
2. Press the Push-to-Start (PTS) button once (1x) to turn the ignition OFF.
Cycle the ignition ON and OFF up to 10 times (10x) by pressing the PTS button twice (2x),
4
then one time (1x) to shut the ignition OFF.
When the LED starts flashing orange slowly, turn the ignition OFF, remove the module from
the vehicle, and reconnect it to your computer.
5
The website will automatically recognize that you are moving onto the second phase of the
programming sequence.
6
Click Submit Key2GO Request.
When the configuration is completed, reconnect the module.
7
The LED will turn ON solid green for 3 seconds, then turn OFF.
You have successfully completed the module programming sequence.
11
403.CHRYSLER22 1.09 2022 Dodge/Ram Charger (Smart Key)
©2023 Directed. All rights reserved.