Table of Contents
Advertisement
Figure 45. Installing the mezzanine card
Next steps
Follow the procedure listed in
Storage controller card
Removing the storage controller card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the following:
a.
Drives
b.
Drive backplane
c.
Drive cage
Steps
1. Using the Phillips #2 screwdriver, loosen the retention screws on the drive cable connector and lift it away from the storage controller
card.
CAUTION:
To prevent damage to the storage controller card, you must hold the card only by its edges.
2. Lift the storage controller card away from the system.
After working inside your system
Safety instructions
Before working inside your system
on page 47.
on page 46.
on page 46.
Installing and removing system components
85
Advertisement
Table of Contents
