11 SERVICE WORK ON THE CHASSIS
11.12
–
Hook the seat using holding lugs
–
Push locking pin
place with an audible click.
–
Check that the seat is correctly mounted.
11.13
50
Mounting the seat
1
3
into lock housing
Removing the tool set
S03285-10
2
on to bushings
, lower the seat at the rear and push it forward.
4
and push the back of the seat down until the locking pin locks in
Preparatory work
–
Open the fuel tank filler cap. (
–
Remove the seat. (
Main work
–
Remove the left side cover from the rubber bushing in area
A
.
–
Remove the left side cover upwards from the bushing in area
B
.
–
Take off the left side cover from the front.
–
Open the tool set compartment and take out tool set
S03282-10
p. 19)
p. 49)
1
.