–
Clean and grease the thread of the wheel spindle and nut
Long-life grease (
–
Clean and grease the wheel spindle.
Long-life grease (
–
Mount the damping rubber and rear sprocket carrier in the rear
wheel.
–
Position the rear wheel.
The brake linings are correctly positioned.
–
Push the rear wheel forward as far as possible and lay the
chain on the rear sprocket.
–
Mount wheel spindle
2
nut
, but do not tighten yet.
–
Make sure that chain adjusters
adjusting screws
Guideline
In order for the rear wheel to be correctly aligned, the mark-
ings on the left and right chain adjusters must be in the
M01388-10
same position relative to reference markings
Info
Mount left and right chain adjusters
position.
–
2
Tighten nut
Guideline
Nut, rear wheel spin-
dle
–
Position wheel speed sensor
–
Mount and tighten screw
Guideline
Screw, wheel speed
sensor
–
Position the brake line in the guide.
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
R05230-10
Finishing work
–
Remove the rear of the motorcycle from the wheel stand.
(
p. 47)
–
Check the chain tension. (
p. 120)
p. 120)
3
and chain adjuster
4
are fitted correctly on
5
.
4
.
M25x1.5
90 Nm (66.4 lbf ft)
6
in the hole.
7
.
M6
6 Nm (4.4 lbf ft)
p. 55)
WHEELS, TIRES 13
2
.
4
. Mount
B
.
in the same
73