Table of Contents
Advertisement
Faults
ABS warning lamp lights up
High oil consumption
Headlight and parking light are
not functioning
Turn signal, brake light and
horn not functioning
Time is not (correctly) dis-
played
12 V battery discharged
Combination instrument shows
nothing in the display
Speedometer in combination
instrument not functioning
Possible cause
Large difference in wheel
speeds of the front and rear
wheels
Malfunction in ABS
Engine vent hose bent
Engine oil level too high
Engine oil too thin (low viscos-
ity)
Fuse 6 blown
Fuse 5 blown
Fuse 1 blown
Ignition not switched off when
vehicle was parked
The 12-V battery is not being
charged by the alternator
Fuse 1 or 2 blown
Speedometer wiring harness is
damaged or plug-in connection
is oxidized
TROUBLESHOOTING 20
Action
–
Stop the vehicle, switch off the igni-
tion, and start it again.
–
Read out the fault memory using the
KTM diagnostics tool.
–
Route the vent hose without bends or
change it if necessary.
–
Check the engine oil level. (
–
Change the engine oil and the oil filter,
clean the oil screens.
(
–
Change the fuses of individual electri-
cal power consumers. (
–
Change the fuses of individual electri-
cal power consumers. (
–
Change the fuses of individual electri-
cal power consumers. (
–
Set the clock. (
p. 21)
–
Charge the 12-V battery.
–
Check the charging voltage.
–
Check the open-circuit current.
–
Change the fuses of individual electri-
cal power consumers. (
–
Set the clock. (
p. 21)
–
Check the wiring harness and plug-in
connection.
p. 97)
p. 97)
p. 82)
p. 82)
p. 82)
(
p. 79)
p. 82)
107
Advertisement
Table of Contents
