Table of Contents
Advertisement
Connections and Setup
DVD Player + TV with Audio/Video Input Jacks
1.
Connect the audio cables to the AUDIO OUT L (left – white) and R (right – r
back of your DVD Player , and to the cor responding Audio Input jacks on your TV .
2.
Connect the video cable(s).
A.
Basic video connection – Connect the video cable (yellow) to the VIDEO OUT jack on
the back of your DVD Player , and to the V ideo Input jack on your TV .
B.
S-Video (optional) – If your TV has an S-V ideo Input jack, connect the S-V ideo cable to
the S-VIDEO OUT jack on the back of your DVD Player and to the S-V
TV. If your TV doesn' t have S-V ideo, use the basic video connection listed above.
C.
Component video (optional) – If your TV has component video (Y , P
use video-grade cables for the Y , P
match the color -coded connectors with a compatible TV . If your TV doesn' t have
component video, use the S-V ideo or Basic video connection listed above.
3.
Set the VIDEO OUT SELECT switch to S-VIDEO or YPbPr , depending on the type of
connection you used. Either setting works for the Basic video connection (2A).
Note: Your cable or off-air connection to the television should not be affected by this
connection. Connect your cable or off-air antenna to your television as you normally
would. You may need to consult your television manual for details.
8
TV (BACK PANEL)
A
DVD PLAYER
A
AYER
(BACK PANEL)
, and P
B
VIDEO
S-VIDEO IN
OR
OR
2A 2B
1
DIGITAL
T
TAL
AUDIO OUT
OPTICAL
OR
OR
connections. Note that it is essential to
R
ANT IN
CABLE OR
OFF-AIR
SIGNAL
2C
3
SELECT
ed) jacks on the
ideo jack on your
, and P
jacks)
B
R
Go to page 14
Chapter 1
Advertisement
Table of Contents
