Install Batteries In The Remote Control; Turn On The Tv And The Dvd Player - RCA DRC300N User Manual

15909460 5/17/02 12:37 PM
Chapter 1: Setup and Connections
Install Batteries in the Remote
1. Remove the battery compartment cover on the back of the remote.
2. Insert new batteries. Match the polarities (+ and –) on the batteries with the diagram on the remote.
3. Put the battery compartment cover back on the remote.
Important Battery Information
• If you're not going to use the remote for a month or more, be sure to remove the batteries because they can
leak and cause damage.
• Dispose of batteries in the proper manner, according to federal, state, and local regulations.
• Any battery may leak electrolyte if mixed with a different battery type, if inserted incorrectly, if all batteries
are not replaced at the same time, if disposed of in fire, or if an attempt is made to charge a battery not
intended to be recharged.
• Discard leaky batteries immediately. Leaking batteries can cause skin burns or other personal injury.
Point the Remote in the Right Direction and Put it in DVD Mode
When you want the remote to operate the DVD Player, point the remote at the DVD Player, not the TV. The remote
has to be pointed in the correct direction and toward the correct component in order for the remote control's signal
to communicate with the sensor on the component. Make sure there is a clear path between the remote control and
the component you want to operate, so the signal isn't blocked.
Make sure the remote is in DVD mode — press the DVD button.
Turn on the TV and DVD Player
1. Turn on your TV and tune it to the correct Video Input Channel (if you don't know which channel is
your the Video Input channel, go to page 60 for help).
2. Press the ON•OFF button to turn on the DVD Player.
8
Page 8