Measurements - ADA INSTRUMENTS Cosmo 40 Operating Manual

 COSMO 40
Reference Setting
Default reference setting is from the rear of the device. Press the button (3) to set the reference: the front or the rear.
When the end-piece is folded out fully, the reference rear is set. You will see the reference symbol on the display.
Selecting Units
Press and hold the button (5) for 2 sec. until the desired unit is displayed.
Clear-Key
Cancel the last action. Press button (4).

MEASUREMENTS

Single distance measurement
Press button (1) to activate the laser. When in continuous laser mode, press this button to trigger the distance
measurement directly. The instrument will give acoustical signal. The result is displayed immediately.