TANNER Scientific Cryostat TN60 Operating Instructions Manual page 31

Picture 2:
Slide the UV lamp as shown into the glass bulb. Keep 2 cm space before the end
position will be reached, this place will be needed to connect the UV Lamp with the
connecting plug. (Pic. 2 & 3)
Picture 4:
The connector can be plugged into two
directions of polarity, a switch is
excluded.
Picture 6:
Once the plug is connected to the UV- Lamp, the final step can be done now and the
UV-Lamp unit can clip into the retaining clips.
31
Picture 3:
Picture 5:
Picture 7:
Manual_TN60_2021-09-001.00_EN_Tanner.docx