Table of Contents
Advertisement
Configuration and diagnostic software Sensor Studio
4.4.2
DTM change
The DTM Change function makes it easier for you to call up the communication DTM of a device or change
from device DTM to communication DTM.
Ä Start the DTM change function in the FDT frame menu by clicking the
NOTICE
Information on DTM change can be found in the online help for the FDT frame menu under Sen-
sor Studio Options.
4.4.3
User management
Using the user management in the FDT frame menu, you can create users, log users in/out and manage
passwords.
Creating users
When creating a user in the user management via Tools > User management in the software frame
menu, select the access level for the user. For information on access permissions and access levels (see
chapter 5.1 "Authorization concept of safety sensor").
Ä In the FDT frame menu, click Tools > User management > Create user.
Logging users in/out
Prerequisites:
• Users have been created
Ä In the FDT frame menu, click Tools > Log in/log out.
Managing passwords
Prerequisites:
• Users have been created
Ä In the FDT frame menu, click Tools > Change password.
NOTICE
Password management via the FDT frame menu applies to all installed device managers (DTM)
of the project.
Whenever write access occurs, the safety sensors of the RSL 400 series always check the ac-
cess level (Engineer, Expert) and the password defined via the device manager (DTM) (SET-
TINGS > Passwords) independently of the password management via the FDT frame menu.
4.4.4
Exiting Sensor Studio
When you have finished making the configuration settings, close the configuration and diagnostics soft-
ware.
Ä Exit the program via File > Exit.
Ä Save the configuration settings as a configuration project on the PC.
You can open the configuration project again at later time via File > Open or with the Sensor Studio Project
Wizard (
).
Leuze electronic GmbH + Co. KG
RSL 440
button.
24
Advertisement
Table of Contents
