Table of Contents
Advertisement
Figure 64. Installing the embedded module
2. When the embedded module is fully seated, push the release lever back into the system until the orange tab locks the lever
in place.
Figure 65. Locking the release lever
3. Connect each cable into the same port from which it was removed.
Power up the node
Power up the node as described in
Verify the operation of a replacement embedded module
Steps
1. From PowerStore Manager, select Hardware.
2. Select the appliance where you replaced the embedded module.
3. On the Components card, under Rear View, expand BaseEnclosure.
4. Expand the node that includes the embedded module, and then select EmbeddedModule.
The status of the replacement embedded module should read Healthy. If the status is still Faulted, wait a few minutes
and refresh PowerStore Manager. If the status does not change, ensure that the embedded module is correctly seated, or
contact your service provider.
Power control
procedures.
Base enclosure service procedures
67
Advertisement
Table of Contents
