Table of Contents
Advertisement
Figure 158. LCC fault LED
About this task
CAUTION:
The DAE must have at least one LCC installed while the enclosure is powered up; do not remove both
LCCs while AC power is on.
Steps
1. Attach an ESD wristband to your wrist and the enclosure.
2. Remove each cable connected to the LCC by gently pulling the connector latches to release the cable from the connector.
Note where the cables connect to the LCC because you will reconnect them later.
Figure 159. Disconnecting an LCC cable
3. Remove the LCC:
CAUTION:
The LCC comes completely out of the DAE chassis. In addition to holding the latches, be prepared
to support the LCC to avoid dropping it.
a. Locate the orange handle buttons on the LCC handles.
SAS expansion enclosure service procedures
CL5982
CL5983
131
Advertisement
Table of Contents
