Table of Contents
Advertisement
The NVMe expansion enclosure contains customer-replaceable components. Follow these procedures to safely replace a failed
component.
NOTE:
Review the information in
Topics:
•
Add a drive in an NVMe expansion enclosure
•
Replace a faulted drive in an NVMe expansion enclosure
•
Replace a power supply module in an NVMe expansion enclosure
•
Replace a fan module in an NVMe expansion enclosure
•
Replace a Clock Distribution Board in an NVMe expansion enclosure
•
Replace an Access Module in an NVMe expansion enclosure
•
Replace a data interface board in an NVMe expansion enclosure
•
Replace a dual inline memory module (DIMM)
Add a drive in an NVMe expansion enclosure
Take the following actions to add a new drive to an NVMe expansion enclosure.
Removing the front bezel
About this task
NOTE:
Remove the front bezel of the expansion enclosure to gain access to the drives. The bezel is required for EMI
compliance when the enclosure is powered up. Remove it only to replace or add a drive.
Steps
1. If the bezel has a lock, insert the key that shipped with your enclosure into the lock, and turn the key to unlock the bezel.
2. Press the two latch buttons on the bezel surface to release the bezel from the cabinet.
3. Pull the bezel off the cabinet, and put it on a clean, static-free surface.
140
NVMe expansion enclosure service procedures
NVMe expansion enclosure service
Safety precautions for handling replaceable units
procedures
before handling replaceable parts.
4
Advertisement
Table of Contents
