Table of Contents
Advertisement
Figure 21. Installing the NVMe expansion enclosure rails (front)
5. Add the retaining screws that came with the rails to the front and back of both rails.
NOTE:
Use the washers that came with the rails if the rack holes are square.
NOTE:
The screw hole at the front of the rail is behind the rail clamp.
NOTE:
You will need a long handled screwdriver to reach the screw hole at the rear of the rack.
NOTE:
The following illustration does not show the C-clips that are used to attach the cable management arms.
Figure 22. Adding the retaining screws
32
Install a new base enclosure and an optional expansion enclosure
Advertisement
Table of Contents
