Embedded Module Leds - Dell PowerStore 1000 Installation And Service Manual

Embedded module LEDs

Use the fault LEDs to identify the faulted part.
Figure 66. Embedded module LEDs
Table 5. Embedded module LEDs
LED
Unsafe to remove
Node power
Node fault
Port link
Ethernet port activity
Ethernet port link
2-port 100GbE card port link
Embedded module fault
2-port 100GbE card port activity
Location State
White
Off
Green
Green blinking
Off
Amber
Blue
Amber or blue
blinking
Blue and amber
alternating (green
for 3 seconds)
Blue and amber
alternating at one
second intervals
Green
Amber
Off
Amber blinking
Off
Green
Off
Green
Off
Amber
Off
Green blinking
Description
Do not remove the node. Improper
removal could cause data loss.
Safe to remove the node when the node
has been properly prepared.
Node is on (main power).
Node is initializing a serial over LAN
session.
Node is off.
Fault has occurred.
Node in Degraded Mode.
System is booting.
System uninitialized. A management IP
address has not been assigned.
Node in Service Mode.
Link up with high speed.
Link up with degraded speed.
Link down.
Port activity.
No port activity.
Link established.
No link established.
Link established.
No link established.
Embedded module has faulted.
No fault has occurred, normal operation.
Port activity.
Base enclosure service procedures 69