Quantum Scalar i500 Getting Started Manual page 8

Scalar i500 Getting Started Guide
Document No. 6-01741-02
October 2008
8
Rear Y-rail
Front Y-rail
From the front of the library, open the I/E station and access doors of the
g
expansion module. Squeeze the handle of the Y-rail release mechanism, lift it out
of its locked position, and slide it downward as far as it will go.
h From the back of the library, find the rear Y-rail release mechanism, which is
located in the interior of the right side of the module. Squeeze the handle of the
Y-rail release mechanism, lift it out of its locked position, and slide it downward
as far as it will go.
Caution: Check to make sure that there is no gap between the top and
bottom Y-rails on both the front and back of the library. If a gap
exists, the library cannot mechanically initialize.
Doing this aligns the Y-rails with the Y-rails of the module beneath it.
Step 3: Install the Module(s)
Y-rail (this end up)
Squeeze here
to release