Introduction - Quantum Scalar i500 Getting Started Manual

Introduction

The Scalar i500 Getting Started Guide provides an overview of the steps required to unpack,
set up, and install the Scalar i500 library. For more detailed information on configuring
and running your library as well as adding, removing, and replacing parts, see the Scalar
i500 User's Guide.
Release Notes are also available for this product. The Release Notes describe changes to
your system or firmware since the last release, provide compatibility information, and
discuss any known issues. The Release Notes can be found at www.quantum.com. You
can find a list of additional documentation in the Scalar i500 User's Guide.
Note: Before operating this product, read all instructions and warnings in this
document and in the System, Safety, and Regulatory Information Guide. In
addition, be sure to use this document in conjunction with the Scalar i500 User's
Guide.
Warning: Without tape drives, tape cartridges, or power supplies, a 5U control
module weighs approximately 58 lbs. A 9U expansion module, without
tape drives, tape cartridges, or power supplies, exceeds 65 lbs. To avoid
serious injury, two people are required to safely lift the modules into
position.
Warning: The power outlet must be available near the library and must be easily
accessible.
Warning: All libraries taller than 14U must be installed in a rack having a main
protective earthing (grounding) terminal, and power must be supplied via
an industrial plug and socket-outlet and/or an appliance coupler
complying with IEC 60309 (or an equivalent national standard) and having
a protective earth (ground) conductor with a cross sectional area of at least
2
1.5 mm (14 AWG).
To ensure proper airflow and access space, Allow 60 cm (24 inches) in the
front and back of the library.
Warning: Under no circumstances should a rack be moved while loaded with one or
more modules.
Introduction
Scalar i500 Getting Started Guide
Document No. 6-01741-02
October 2008
0
3