Quantum Scalar i500 Getting Started Manual page 7

2 Remove top or bottom cover plates if necessary.
There should only be one top cover and one bottom cover plate in the final
configuration. There should be no cover plates in between modules.
3 Install the expansion module(s).
a Open the expansion module's access door and raise the guide pin by pulling it up
and turning it slightly as if it were a screw. Otherwise, the guide pin may scratch
the front doors of the module on which you are stacking.
Guide pin
b Lift the new expansion module and, from the front of the library, place it in the
desired location.
c If stacking the expansion module on top of another module, lower the module's
guide pin (located at the base of the front of the module) by turning it and
pushing it down. Then secure the two modules together by tightening the two
thumbscrews at the base of the front of the module and the two thumbscrews
located at the base of the back of the module.
d Tighten all thumbscrews located at the base of the front and back of the modules.
If installing in a rack, secure the module in the rack using rack ears. For
e
instructions, see the Scalar i500 User's Guide.
f If stacking the expansion module on top of another module, engage the Y-rails of
the new module in your library configuration. Ensure that the Y-rails are properly
aligned and the thumbscrews are tightened.
Step 3: Install the Module(s)
Thumbscrew
Scalar i500 Getting Started Guide
Document No. 6-01741-02
October 2008
7