Unpacking The Internal Sata-To-Usb Tape Drive; Installing The Internal Sata-To-Usb Tape Drive; Dlt-V4 Product Manual - Quantum DLT V4 User Manual

Unpacking the Internal SATA-to-USB Tape Drive

Installing the Internal SATA-to-USB Tape Drive

DLT-V4 Product Manual

Chapter 4 Installing the Internal SATA-to-USB Tape Drive
Before you do anything else, unpack and inspect the tape drive for
shipping damage. If you notice any damage, report it both to the sales
representative and to the shipping company immediately.
Save the packing materials in case you need to move or ship
Note:
the tape drive in the future. You must ship the tape drive in
the original (or equivalent) packing materials or you will
invalidate the warranty.
If there is no damage to the tape drive, select a server or workstation to
host the tape drive, then move on to the following installation steps.
To install the tape drive, follow these steps:
Shut down the operating system and power off the server or
1
workstation.
Power off all peripheral devices, such as printers and other connected
2
devices.
Do not go to step 3 until you have completed steps 1
Caution:
and 2. Failure to follow these instructions may result
in damage to the tape drive or other devices.
Unpacking the Internal SATA-to-USB Tape Drive
4
4
25