Powering The Terminator; Figure 22 Tabletop Scsi Tape Drive Rear Panel Connections; Dlt-V4 Product Manual - Quantum DLT V4 User Manual

Powering the Terminator

Figure 22 Tabletop SCSI Tape
Drive Rear Panel Connections
Terminator
(or cable to
next SCSI
device)
SCSI cable
(to computer or
previous SCSI
device)

DLT-V4 Product Manual

At least one device on the SCSI bus must supply terminator power
5
( ). The factory default for the tape drive is for
TERMPWR
enabled. Only an authorized service provider can disable the tape drive
setting. Attach the terminator as shown in
TERMPWR
It is acceptable for more than one device on the SCSI bus to
Note:
provide
Chapter 5 Installing the Tabletop SCSI Tape Drive
Terminating the SCSI Tabletop Tape Drive
.
TERMPWR
Power cord
to be
TERMPWR
figure 22.
41