Chapter 2 Installing The Internal Scsi Tape Drive; Equipment Required; Scsi Bus And Cable Requirements - Quantum DLT V4 User Manual

Quantum dlt v4: user guide

Hide thumbs Also See for DLT V4:

Table of Contents

DLT-V4 Product Manual

This chapter contains step-by-step instructions for installing the internal

SCSI tape drive.

All you need to install the DLT-V4 internal SCSI tape drive is a

PHILLIPS® screwdriver and adequate ESD protection.

The DLT-V4 SCSI interface tape drive incorporates a wide Ultra160 low-

voltage differential (LVD) small computer system interface (SCSI) bus,

but you can also attach it to a single-ended (SE) SCSI bus.

Make sure the SCSI host adapter or controller supports these

configurations. If you connect the tape drive to an SE bus, or if there are

SE devices attached to the same SCSI bus, the tape drive's performance is

limited to the maximum data transfer speed and maximum cable lengths

of the SE bus (usually 40 MB/s). The DLT-V4 is not compatible with a high-

voltage differential (HVD) SCSI bus.

Installing the Internal

SCSI Tape Drive

Chapter 2

Table of Contents