Chapter 5 Installing The Tabletop Scsi Tape Drive; Equipment Required; Scsi Bus And Cable Requirements; Dlt-V4 Product Manual - Quantum DLT V4 User Manual

Quantum dlt v4: user guide

Hide thumbs Also See for DLT V4:

Table of Contents

This section contains step-by-step instructions for installing the tabletop

SCSI tape drive.

You need no special tools to install the DLT-V4 SCSI tabletop tape. You

will need a ballpoint pen to change the SCSI ID switch on the rear panel

of the tape drive.

The DLT-V4 SCSI interface tape drive incorporates a wide Ultra160 low-

voltage differential (LVD) small computer system interface (SCSI) bus,

but you can also attach it to a single-ended (SE) SCSI bus.

Make sure the SCSI host adapter or controller supports these

configurations. If you connect the tape drive to an SE bus, or if there are

SE devices attached to the same SCSI bus, the tape drive's performance is

limited to the maximum data transfer speed and maximum cable lengths

Installing the Tabletop

SCSI Tape Drive

Chapter 5

Table of Contents