Table 20 - Parts Needed To Make Rs-485 Cable - Honeywell 900U02-0100 User And Installation Manual

Part #
Belden #9271 (or equivalent),
with 120 ohm resistors (2,000
feet Maximum)
Or
Belden #9182 (or equivalent),
with 150 ohm resistors (4, 000
feet maximum)
Phoenix #1840379 (or
equivalent) for C30/C50
Phoenix 1803581 for C75.
047260
089037
7.4. Connecting the ControlEdge HC900 Controller to a PC with
the Designer Software
To establish communications between the ControlEdge HC900 controller and the Process Control (HC)
Designer configuration software use any of the following methods.

A. Direct Serial RS-232 connection. See page 142. Direct with RS-485 and RS-485 to USB
converter with supplied instructions.

B. Modem connection. See page 144.

C. Direct Ethernet connection. See page 157.

D. Networked Ethernet connection. See page 158.
These methods are described below.
ATTENTION:
Always observe the wiring/cabling guidelines on page 58.
Revision 10 ControlEdge HC900 Process & Safety Controller User and Installation Manual
May 2019
Table 20 – Parts needed to make RS-485 Cable
Quantity
Variable Commercially available communication
cable
1 10-terminal connector (Supplied with the
operator interface)
1 Connector (3-pin) (Supplied with the
controller CPU module)
1 Ferrite cable clamps (Supplied with the
operator interface)
2 Nylon cable ties
Description
143