Installing An Adapter - IBM eserver xSeries 450 Option Installation Manual

3. To remove the power supply from the server, press the latch; then, lift the
4. Install the new power supply:
5. Verify that the dc power LED and the ac power LED on the power supply are lit,
6. Replace the front bezel on the server (see "Removing and replacing the bezel"

Installing an adapter

The following notes describe the types of adapters that your server supports and
other information that you must consider when installing an adapter:
Attention:
the nonvolatile random access memory (NVRAM), be sure to make a backup copy
of the nonvolatile EFI variables. See "Backing up and restoring the nonvolatile
variables" on page 39 for more information.
v The following illustration shows the location and bus speeds of the PCI-X
handle on the power supply to the open position and pull the power supply out
from the server.
Power supply
Power-supply
latch
Power-supply handle
(in open position)
a. Place the handle on the power supply in the open position.
b. Slide the power supply into the chassis and press the handle to the closed
position.
indicating that the power supply is operating properly.
on page 14 for instructions).
Before you remove or replace the Remote Supervisor Adapter or clear
expansion slots on the PCI-X board.
AC LED
DC LED
Chapter 2. Installing options
17