Installing Memory - IBM eserver xSeries 450 Option Installation Manual

3. Push the drive-eject button to the right.
4. Inspect the drive for any signs of damage.
5. Slide the CD-ROM or DVD-ROM drive into the drive bay until it stops.
6. If you have other options to install or remove, do so now. Otherwise, connect
Complete the following steps to remove a CD-ROM or DVD-ROM drive in your
server:
1. Read the safety information beginning on page v and "Installation guidelines" on
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Push the drive-eject button to the right.
4. Using the tab, pull the CD-ROM or DVD-ROM drive partially out of the server;
5. If you have other options to install or remove, do so now. Otherwise, connect

Installing memory

The following notes describe the types of dual inline memory modules (DIMMs) that
your server supports and other information that you must consider when installing
DIMMs:
v Your server supports 512 MB, 1 GB, and 2 GB DIMMs, for a maximum of 40 GB
Removable
media bays
CD-ROM
or DVD drive
Tab
the power cords and turn on the server.
page 11.
all external devices from the back of the server.
then, grasp the drive and remove it from the server.
the power cords and turn on the server.
of system memory. Your server supports up to twenty-eight 2.5 V, 184 pin,
PC2100, ECC DDR SDRAM, 133 MHZ DIMMs. Go to the ServerProven
http://www.ibm.com/pc/compat/ for a list of memory modules you can use with
your server.
CD-ROM drive
eject button
Chapter 2. Installing options
®
list at
23