IBM eserver xSeries 450 Option Installation Manual page 41

7. If you are installing a new microprocessor, go to step 8; otherwise, continue:
Attention: Failure to complete the instructions in the prescribed order might
cause damage to the microprocessor pins and cause the microprocessor to
fail.
Microprocessor
Power module
a. Using the T-handled Torx wrench provided with the microprocessor option,
completely loosen the power-module screws.
b. Slide the power module from the microprocessor and remove the power
module.
c. Completely loosen the heat-sink screws.
d. Use the hex wrench provided with the microprocessor option to open the
socket lock and remove the microprocessor.
8. Install the microprocessor and power module:
Levers
Chapter 2. Installing options
29