NEC EXP801 Maintenance Manual page 147

Chapter 3 Appendix
Error Message
Hardware configuration
C302
error.
FAN Structure ID command
C303
error.
Necessary to update SDR
C304
Version for new RAID Card.
C310 Hardware configuration of
cooling is insufficient.
C320 Unmatched PSUs.
C321 System power consumption is
out-of-range in PSUs.
C322 No information for system
power consumption check.
C323 Internal Use Area of BMC FRU
is incompatible.
C501 ME is in Recovery Mode.
C600 Internal Flash is not valid.
C624 Invalid internal BIOS
Configuration Data.
C625 BIOS Configuration Data
Send Error.
C626 BIOS Configuration Data
Read Error.
C627 BIOS Configuration Data
Write Error.
C628 System configuration data
cleared by System Boot
Options command.
Cause
Illegal hardware configuration
was detected.
Illegal fan control was detected
when RAID Controller is
installed.
SDR for RAID Controller is
inappropriate.
Detected that cooling power is
insufficient in this hardware
configuration.
Unmatched power supply units
are configured.
System power consumption
exceeds the power output
capacity limit.
No information is acquired in
checking system power
consumption.
The FRU of hardware
information is incompatible.
Intel Node Manager is
Recovery Mode.
Selected Internal Flash Memory
as an onetime booting device
but unable to enable it.
Internal error of BIOS
Configuration Data was
detected.
An internal error was detected
during sending BIOS
Configuration Data.
An internal error was detected
during reading BIOS
Configuration Data.
An internal error was detected
during writing BIOS
Configuration Data.
The SETUP setting was cleared
by Set System Boot Options of
the standard IPMI command.
Express5800/R120g-1M, R120g-2M Maintenance Guide
Action
Contact your sales representative.
Unplug the power cord, wait for at least 30
seconds, then restart the server.
Unplug the power cord, wait for at least 30
seconds, then restart the server. At that time,
check the jumper switch setting on motherboard.
Unplug the power cord, wait for at least 30
seconds, then restart the server.
Run SETUP and specify each items.
1. POST Error Message
147