PSEN sl-1.0p 1.1/1.1 VA
Align the safety switch to the actuator and tighten the screws.
Adjustment
The stated operating distances (see Technical details:
}
actuator [
tuator and stainless steel base plate and actuator [
switch and actuator are installed facing each other in parallel. Operating distances may
deviate if other arrangements are used.
Note the maximum permitted lateral and vertical offset (see
}
offset [
Operation
Operating Manual PSEN sl-1.0p 1.1/1.1 VA
1003821-EN-12
27],
System with free-moving [
11]).
NOTICE
The safety function should be checked after initial commissioning and each
time the plant/machine is changed. The safety functions may only be
checked by qualified personnel.
CAUTION!
Contaminated surfaces can reduce the holding force of the locking magnet.
Make sure that the contact surfaces are clean.
System with normal
30]actuator,
System with normal ac-
34]) only apply when the safety
Lateral and vertical
23