Reprinting Pages After Fault Condition - Printronix L5535 User Manual

Reprinting Pages After Fault Condition

buffer, it will then be printed. Press ONLINE to place the printer
online.
The "stacker" errors can usually be cleared by pressing CLEAR. In
some cases, you may need to lower and then raise the stacker tray,
then press CLEAR to correct the error.
Errors requiring field service are printer failures that require the
attention of service personnel. Before calling your service
representative, press CLEAR to attempt to remove the message
from the display. If the message disappears, the original message
may have been a false error indication. If the message reappears,
call for service.
Errors requiring reprinting are those errors which require reprinting
to recover from an error condition. These are discussed in detail in
the following topics.
IMPORTANT
The stacker is reset automatically whenever you clear a paper
fault (paper jam or fanfold paper empty) error.
Reprinting Pages After Fault Condition
The printer handles errors in three ways, depending on your
configuration of the Reprint on Fault option in the Paper Control
menu.
If Reprint on Fault is enabled (the default):
Any pages left in the printer at the time of failure will be reprinted.
No data is lost.
Fanfold paper: the printer reprints all pages that have not
completely exited the printer at the time of failure. The exact
number of pages that are reprinted is determined by the length of
the page and where within the page the fault occurred.
Cut sheet paper: the printer determines how many pages did not
exit the printer, and reprints all pages that did not exit.
If Reprint on Fault is disabled:
223