Centronics Parallel Interface Configuration
The printer is configured for the Centronics interface via the
Centronics Interface menu, as described on page 76. The following
interface configuration parameters may be modified to meet
specific application requirements:
Data Bit 8
PI Ignored
Data Polarity
Resp. Polarity
Busy On Strobe
Latch Data On
Prime Signal
TOF Action
Buffer Size In K
Note: Only the factory default settings are shown above. See page
76 for additional options.
Centronics Parallel Interface
Enable
Disable
Standard
Standard
Enable
Leading
Enable
Reset
64
271