Chapter 2
Powering On The Printer
Powering On The Printer
1
CAUTION
The printer must be connected to a 220-240 VAC, 30 Amp, 50-
60 Hz power source, as shown on the rear panel label. Using
an incorrect power source may damage the printer.
1. Turn on the printer by setting the power switch to | (on).
2. Note that when you power on the printer, the following occurs:
a. The printer reads the emulation boot file and displays the
b. If there are no bootup errors, the LCD displays:
c. STAND BY Light Flashes
d. The ONLINE indicator lights continuously and STAND BY
40
Legend:
1)
Power Switch
message:
"TESTING HARDWARE
PLEASE WAIT..."
"DIAGNOSTICS PASSED"
goes out.