Mechanical Installation; Vertical Wall Mount - Delta M70A-262 Operation And Installation Manual

3.2 Mechanical Installation

This unit is designed to be wall-mounted per Section 3.2.1 or ground mounted
Section 3.2.2.

3.2.1 Vertical Wall Mount

Refer to Figure 3-4 to Figure 3-9.
1. Ensure the surface to which the unit is to be mounted is sufficiently strong
enough to carry the weight.
2. Orient the wall bracket (Figure 3-4) horizontally (perpendicular to the floor).
3. Secure the mounting bracket on the wall with 12 M6 screws.(Figure 3-5)
4. Hang the inverter on the wall mounting bracket.
5. Secure the inverter by 2 M6 screws on the position* shown as Figure 3-5.
* These are also grounding points for equipment grounding. (To ground the
inverter, please refer to Section 3.5.2)
- The mounting bracket shipped with the unit is specially designed and is the only
certified mounting device for mounting the inverter.
- Secure the mounting bracket on the wall with 8 M6 screws.
- Failure to comply with following mounting instructions including permitted
orientations and designated clearances may result in derated power output
and may void the warranty.
CAUTION !
21
Installation