Mechanical Installation; Vertical Wall Mount - Delta M50A 261 Operation And Installation Manual

3.2 Mechanical Installation

This unit is designed to be wall-mounted per Section 3.2.1 or ground mounted
Section 3.2.2.

3.2.1 Vertical Wall Mount

Refer to Figures 3-4 through Figures 3-9.
1. Ensure the surface to which the unit is to be mounted is sufficiently strong
enough to carry the weight.
2. Orient the wall bracket (Figure 3-4) horizontally (perpendicular to the floor).
3. Secure the mounting bracket on the wall with 12 M6 screws.(Figure 3-5)
4. Hang the inverter on the wall mounting bracket.
5. Secure the inverter by 2 M6 screws on the position* shown as Figure 3-5.
* These are also grounding points for equipment grounding. (To ground the
inverter, please refer to Section 3.5.2)
- The mounting bracket shipped with the unit is specially designed and is the only
certified mounting device for mounting the inverter.
- Secure the mounting bracket on the wall with at least 6 M6 screws.
- Failure to comply with following mounting instructions including permitted
orientations and designated clearances may result in derated power output
and may void the warranty.
To avoid malfunction of inverter caused by extreme
weather (ex: snow, hail...etc) or non-proper installation/
maintenance, an additional protection cover is strongly
recommended to be installed by DELTA.
For more details, please contact local service team.
CAUTION !
CAUTION !
21
Installation
Protection cover