Entry Queue Dial-In Number Table - Polycom MGC-25 Getting Started Manual

7. To enable Ad Hoc conferencing, select the Ad Hoc check box, and in the
Profile box, select the Profile from which the target conference
properties are to be taken. Profiles must be defined before enabling the
Ad Hoc option. For information about defining Ad Hoc Conferences, see
the MGC Manager User's Guide, Volume II, Chapter 3.
8. In the Target Conferences box:
a. Select the Audio Only check box to define an Audio Only Entry
Queue. If the Audio Look & Feel mode is enabled in the MGC
Manager, this option is automatically selected. Audio Only
participants can connect to a video Entry Queue, and you do not
have to define a separate Entry Queue for Audio Only participants.
This action disables the Target Conference Settings pane.
b. To create an IP Only Entry Queue, select the IP Only check box.
This disables the Dial-in Numbers Pane.
c. To encrypt the Entry Queue, select the Encryption check box. In
Audio conferences, encryption is only enabled for VoIP.
9. If you selected the IP Only Target Conference, configure the audio
algorithm to use for Entry Queue VoIP participants. The Target
Conference Settings Audio Alg settings provide additional audio options
such as G.723/G.729.

Entry Queue Dial-in Number Table

Dial-in numbers are relevant to ISDN and T1-CAS participants only.
H.323 participants can dial in to an Entry Queue by dialing the Network Service
Prefix and the Numeric ID or Name of the Entry Queue using the following
format: [(Prefix)(Entry Queue Numeric ID or Name)].
SIP participants use the Entry Queue URI to connect to the Entry Queue using
the following format: [(Entry Queue Name)@(domain name)].
The list of dial-in numbers assigned to the Entry Queue is displayed in the
Dial-in Numbers table. Up to 16 dial-in phone numbers may be assigned to
the Entry Queue.
If no dial-in number is assigned to the Entry Queue, the system assigns a dial-in
number from the dial-in numbers ranges defined in the ISDN Network Service.
The number is assigned only when the Entry Queue definition is saved by
clicking the OK button. This dial-in number is displayed in the Status pane. For
more information, see Chapter 5, "Dialing-in to a conference" on page 5-4.
Chapter 6 - Defining a New Audio Conference
6-3