Removing The Front Panel And Door Switch - Whirlpool Maytag W11416805 Technical Manual

Removing the Front Panel and Door Switch

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dryer or disconnect power.
2. Perform procedures on page 4-2,
Console/User Interface (UI) and Top
performing the following steps.
3. Remove the four TORX T-20 screws as shown in below
Figure.
4. Disconnect the door switch connector and unclip door
switch harness from the side panel as shown in below
Figure.
"Removing the
Panel" before
COMPONENT ACCESS (Cont.)
NOTE: Refer to Figure A for the following 3 steps.
5. Open dryer door and remove the lint screen. Next, remove
the three (3) TORX T-20 screws.
6. Remove four (4) 1/4" hex-head screws from the bottom of
the front panel.
7. Remove two (2) Phillips screws from the lint screen.
A. TORX T-20 Screw
B. Phillips Screw
8. Lift the front panel assembly up off the tabs and away from
the dryer. Route the door switch harness around the front
console bracket.
9. Locate the door switch on the backside of the front panel,
just above the door opening. Depress both tabs and push
switch through the opening.
Whirlpool® and Maytag® Dryer
A
B
C
Figure A
C. Hex-head Screw
4-5
n