Removing The Front Panel - Whirlpool Duet Sport WED8300SW Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. Remove the console from the dryer (see
page 4-2 for the procedure).
4. Remove the door switch (see page 4-5
for the procedure).
5. Open the dryer door and remove the lint
filter.
6. Remove the two screws from the outlet
grille and then close the dryer door.
Lint Filter
Outlet Grille Screws
7. Remove the screws from the toe panel
and remove the panel (see the top right
photo).

REMOVING THE FRONT PANEL

Toe Panel Screws
8. Remove the two screws from the bottom
of the front panel.
Front Panel Bottom Screws
NOTE: When you remove the two screws in
the next step, support the front panel so that
it does not fall.
9. Remove the two screws from the top of
the front panel and remove the panel
from the dryer.
Top Front Panel Screws
Remove
Front
Panel
4-8