Removing The Front Panel - Whirlpool 4.3 CU FT Service Manual

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
To Remove the Front Panel
1. Unplug dryer or disconnect power.
2. Perform the procedure on page 4-8, "Remove the Door
Assembly" prior to performing the following steps.
3. Perform the procedure on page 4-9, "Remove the Top
Panel" prior to performing the following steps.
4. Perform the procedure on page 4-9, "Remove the Side
Panels" prior to performing the following steps.
5. Perform the procedure on page 4-11, "Remove the
Console/User Interface" prior to performing the following
steps.
6. Remove door lint filter and bottom HX Filter.
7. Remove the two T20 Torx screws on the opposite side of
the door hinge (see Figure 1).

Removing the Front Panel

Remove 2
T20 Screws
Figure 1
8. Using a T20 Torx driver, remove the 4 inside screws, 2 on
each side of the inner front panel. See Figure 2.
Remove two (2) T20
screws on each side of
inner front panel.
9. Pull front panel away from the front bulkhead.
Whirlpool Compact Heat Pump Dryer
COMPONENT ACCESS
Figure 2
4-17
n