Ip Filter Config - D-Link DWR-953 User Manual

Section 3 - Configuration
An IP Filter is an advanced feature that allows you to drop IP traffic based on specific rules. Each IP packet is marked with a source address, destination
address, and ports.
Tick the Enable box to activate this filter.
IP Filter:
Name:
Input the name of the filter. The name is for reference purposes
only and does not affect functionality.
Start Source
Specify the source IP or IP range to which the rule will apply. To
IP:
specify a range, enter the start of the range in this box. To specify
a single IP, enter the same address in the Start and End boxes.
End Source
Specify the source IP or IP range to which the rule will apply. To
IP:
specify a range, enter the end of the range in this box. To specify a
single IP, enter the same address in the Start and End boxes.
Source Port:
Indicates the source port or port range to which the rule will apply.
To specify a port range, enter in the format of Start:End.
Start
Specify the destination IP or IP range start to which the rule will
Destination
apply. To specify a range, enter the start of the range in this box.
IP Address:
To specify a single IP, enter the same address in the Start and End
boxes.
End Specify the destination IP or IP range end to which the rule will
Destination apply. To specify a range, enter the end of the range in this box.
IP Address:
To specify a single IP, enter the same address in the Start and End
boxes.
D-Link DWR-953 User Manual

IP Filter Config

57