Table of Contents
Advertisement
en Before using for the first time
2.
Insert the universal pan between the two guide rods
for a shelf position. In so doing, the wire rack is on
top of the upper guide rod.
Wire rack
on univer-
sal pan
7 Before using for the first time
Configure the settings for initial start-up. Clean the appliance and accessories.
7.1 Determining the water hardness before switching on the appliance for the first time
Before using the appliance for the first time, ask your
water supplier about the hardness of your tap water. To
ensure that the appliance can reliably remind you to
descale it when required, you must set your water hard-
ness range correctly.
ATTENTION!
If the wrong water hardness has been set, the appli-
ance cannot remind you to descale it at the right time.
▶
Set the water hardness correctly.
Using unsuitable liquids may damage the appliance.
▶
Do not use distilled water, highly chlorinated tap wa-
ter (>40 mg/l) or other liquids.
▶
Only use cold, fresh tap water, softened water or
non-carbonated mineral water.
Setting
1
0 (softened)
1 (soft)
2 (medium)
3 (hard)
2
4 (very hard)
Only set this if you will be using solely softened water.
1
Also set for mineral water. Only use non-carbonated mineral water.
2
7.2 Initial use
After connecting the appliance to the power supply,
you must configure the settings for its initial start-up. It
may take a few minutes for the settings to appear on
the display.
Notes
¡ You can adjust the settings at any time in the basic
settings.
→ "Basic settings", Page 23
¡ You can also use Home Connect to configure the
settings. When your appliance is connected, follow
the instructions in the app.
→ "Home Connect ", Page 24
12
6.3 Other accessories
You can purchase other accessories from our after-
sales service, specialist retailers or online.
You will find a comprehensive range of products for
your appliance in our brochures and online:
www.neff-international.com
Accessories vary from one appliance to another. When
purchasing accessories, always quote the exact
product number (E no.) of your appliance.
You can find out which accessories are available for
your appliance in our online shop or from our after-
sales service.
Malfunctions may occur when using filtered or deminer-
alised water. The appliance may request that you top
up the water tank even though it may be full, or opera-
tion with steam is cancelled after approx. two minutes.
▶
Notes
¡ If you are using mineral water, set the water hard-
¡ If your tap water is very hard, we recommend that
Water hardness in
mmol/l
-
Up to 1.5
1.5-2.5
2.5-3.8
Over 3.8
Setting the language
Requirement: The appliance is connected to the power
supply.
1.
2.
3.
4.
Setting up Home Connect
Note: You can skip Home Connect set-up by pressing
"Later". Next, set the clock.
1.
If required, mix filtered or demineralised water with
the bottled non-carbonated mineral water with a ra-
tio of one to one.
ness range to "very hard". If you are using mineral
water, you must only use non-carbonated mineral
water.
you use softened water. If you are using only
softened water, set the "softened" water hardness
range.
German hardness °dH
-
Up to 8.4
8.4-14
14-21.3
Over 21.3
Press
to switch the appliance on.
Swipe left or right to select the required language.
Press the required language.
Press
to confirm the language.
Press "Connect" to set up Home Connect.
→ "Home Connect ", Page 24
French hardness °fH
-
Up to 15
15-25
25-38
Over 38
Advertisement
Table of Contents
