Communicating With Other Station - Yaesu WIRES-X FT3DE Instruction Manual

Communicating with other station

（1） Access Point
1. Access the "frequency" and "WIRES-X DG-ID number" of another C4FM digital transceiver according to the portable
node station for details, refer to the Operating Manual (WIRES-X Edition) of the transceiver.
2. Press the PTT switch on the other transceiver to communicate with the other station on the Internet.
3. Release the PTT switch to return to receive mode.
• When the transceiver of the portable node is transmitting (downlink), "Access Point" or "Direct Operation" may not be
switched by pressing the [A/B] key or the
• In the Access Point, a node or a room on the Internet may be connected by operating from another C4FM digital
transceiver accessing the portable node. For details, refer to the Operating Manual (WIRES-X Edition) of each
transceiver.
（2） Direct Operation
The FT5D/FT3D/FT2D also has the capability to be used only in the Direct Operation. For details, please refer to "FT5D/
FT3D/FT2D Direct Operation dedicated function" (page 75).
1. Press the PTT switch on the transceiver of the portable node to communicate with the other station.
The TX/BUSY LED lights red but does not transmit radio waves, so the PO meter does not fluctuate.
2. Release the PTT switch to return to receive mode.
he TX/BUSY LED lights green while receiving communication from the other station on the Internet, but the S meter
T
does not fluctuate.
In "Direct Operation" of Portable HRI Mode with an FT5D/FT3D/FT2D transceiver, the audio from the other station
is heard only from the PC speaker. To adjust the receive volume level, turn the VOL knob of the transceiver, or adjust
the PC speaker volume.
⿟ Confirming the location of the other station
When latitude and longitude data is included in the signal of the other station, the distance and direction of the other
station may be displayed in real time on the transceiver screen.
FT5D:
FT3D or FT2D:
FTM-500D:
FTM-400XD/D:
FTM-300D or FTM-200D: Press the [DISP] key on the connection screen to display the compass screen. Press the
FTM-100D:
On the "BACKTRACK" screen (compass screen), operation may not be switched between "Access Point" or "Direct
Operation" by pressing the [A/B] key or the
key (FTM-500D only).
] key to display the compass screen. Press the [F
Press the [F
menu
return to the normal screen.
Press the [DISP] key to display the compass screen. Press the [DISP] key again to return to
the normal screen.
Press the [DISP] key to display the compass screen. Press the [DISP] key again to return to
the normal screen.
Press the [DISP] (SETUP) key to display the compass screen. Press the [DISP] (SETUP)
key twice to return to the normal screen.
[DISP] key again to return to the normal screen.
The callsign of the other station, and the direction and distance are displayed alternately at
the top of the screen automatically.
key (FTM-500D only).
62
] key again to
menu