Communicating With Digital Or Analog Fm Mode (Portable Hri Mode) - Yaesu WIRES-X FT3DE Instruction Manual

Portable digital node function
Hide thumbs Also See for WIRES-X FT3DE:
Table of Contents

Advertisement

Communicating with digital or analog FM mode (Portable HRI Mode)

 FT5DR/DE, FT3DR/DE or FT2DR/DE
Since the cable connection for the FT5D/FT3D/FT2D transceiver differs between Access Point and Direct Operation,
please refer to the following and make the connections according to the mode to be used.
《When operating in Access Point》
1. For the WIRES-X Node mode connection, use the SCU-55 or SCU-19 USB Connection Cable, the CT-44
adapter and two audio cables that are supplied in the SCU-57 or SCU-39 Connection Kit (sold separately) as
shown in the figure.
DATA Jack
MIC/SP Jack
• To prevent RF interference, keep the antenna of the transceiver as far away from the connecting cables and PC as possible.
• It is recommended to set the transmit output power of the transceiver as low as possible for the desired communication.
The connection is complete.
After completing "Initial Setting (setting is required only once at the beginning)" (page 15), the volume level of
the microphone and PC speaker must be set by referring to "Adjusting Audio Level in the Access Point (Portable
HRI Mode)" (page 69).
《When operating in Direct Operation》
1. For the WIRES-X Direct mode connection, use the SCU-55 or SCU-19 USB Connection Cable, the CT-44
adapter and one of the audio cables that are supplied in the SCU-57 or SCU-39 Connection Kit (sold
separately) as shown in the figure.
DATA Jack
MIC/SP Jack
The connection is complete.
In "Direct Operation" of Portable HRI Mode with FT5D/FT3D/FT2D transceiver, the audio from the other station is heard only
from the PC speaker. After completing "Initial Setting (setting is required only once at the beginning)" (page 15), the
volume level of the microphone and PC speaker must be set by referring to "Adjusting Audio Level in the Direct Operation
(Portable HRI Mode)" (page 71).
To adjust the receive volume level, turn the VOL knob of the FT5D/FT3D/FT2D transceiver, or adjust the PC speaker volume.
SCU-55 or SCU-19
Φ2.5 plug (Black)
Φ3.5 plug (Black)
Φ3.5 plug (Gray)
SCU-55 or SCU-19
Φ3.5 plug (Gray)
Φ3.5 plug (Gray)
Φ3.5 plug (Gray)
13

Advertisement

Table of Contents
loading

Table of Contents