Table of Contents
Advertisement
Communicating with other station
1. Press the PTT switch on the transceiver of the portable node to communicate with the other station.
• In the Access Point, the signal is relayed to the Internet station and also transmitted from the C4FM digital radio
at the same time.
• In the Direct Operation, the signal will only be relayed to the other station on the Internet. The TX/BUSY LED
lights red but the transceiver does not transmit radio waves, so the PO meter does not swing.
2. Release the PTT switch to return to receive mode.
• In the Access Point operation, the voice from the other station on the Internet sounds from the speaker, and
at the same time the C4FM digital signal is transmitted. Also, the voice from another C4FM digital transceiver
accessing the portable node will sound on the speaker, and at the same time it will be relayed to the other station
on the Internet.
• In the Direct Operation, the TX/BUSY LED lights green while receiving communication from the other station on
the Internet, but the S meter does not swing.
• In the Access Point operation, when setting a
to the same number. A node that is set to a different number will not work properly.
• When setting the receive DG-ID number to "00" and setting the transmit DG-ID number to anything other than "00", the
voice of all received C4FM digital stations will be heard on the speaker, but for the transmit DG-ID Only the matched
communication is relayed to the opposite station on the Internet.
Disconnecting from the node or room
To disconnect a connected Internet node or room, use the transceiver below or select [Disconnect] from the [Connect]
menu of the WIRES-X software.
FT5D, FT3D or FT2D: Press and hold the [BAND] key.
FTM-400XD/D, FTM-300D, FTM-200D or FTM-100D: Press and hold the [
Closing the WIRES-X software
1. From the "File" menu, select "Exit"
If "Enable WIRES-X Auto Start." has been selected when
installing the WIRES-X software, the software will restart
immediately after closing the software.
If you do not want to restart the software, click the
WIRES-X icon on the right part of the Windows task bar (or
from the hidden indicator list), then select "Quit" or "Auto
Start" to remove the check mark.
Confirming the location of the other station
When latitude and longitude data is included in the signal of the other station, you may check the distance and direc-
tion of the other station in real time on the transceiver screen.
FT5D:
FT3D or FT2D:
FTM-400XD/D:
FTM-300D or FTM-200D: Press the [DISP] key on the connection screen to display the compass screen. Press the
FTM-100D:
receive
Press the [F menu] key, then touch [DISP] to display the compass screen. Press the
[F menu] key again to return to the normal screen.
Press the [DISP] key to display the compass screen. Press the [DISP] key again to return to
the normal screen.
Press the [DISP] (SETUP) key to display the compass screen. Press the [DISP] (SETUP)
key twice to return to the normal screen.
[DISP] key again to return to the normal screen.
Press the [DISP] (SETUP) key to display the compass screen. Press the [DISP] (SETUP)
key twice to return to the normal screen.
DG-ID number (except for "00"), set the
46
transmit
DG-ID number
] key on the microphone.
Advertisement
Table of Contents
