Yaesu WIRES-X FT3DE Instruction Manual page 6

⿟ Direct Operation （Portable HRI Mode）
In this mode, you can communicate in digital mode or analog mode via the Internet. WIRES-X communications are
made directly by using the USB connected Portable Digital Node Station Transceiver. The microphone signal is sent
only to the PC and the Internet. The Internet signals are heard only in the Portable Digital Node Station transceiver
speaker. (When communicating in "Direct Operation" on "Portable HRI Mode" using FT5D, FT3D or FT2D, the Inter-
net signals are heard only from the PC speaker.) In this Direct Operation, the Portable Digital Node Station transceiver
does not transmit or receive over the air.
Direct Operation ( Portable HRI Mode ) Illustration
Press the PTT switch on
the transceiver connected
to the PC to communicate.
With the WIRES-X Portable Digital Node function, you cannot operate a WIRES-X Room (Including a digital room) or use
the remote-control function from the outside.
Portable Digital Node Station
FT5D/FT3D/FT2D
FTM-500D
FTM-400XD
FTM-200D
FTM-100D
FTM-300D
WIRES-X Node Station
Digital Node Station
C4FM Digital
WIRES-X Room
Digital Node Station
C4FM Digital
5
Analog Node Station
Analog FM
Analog Node Station
Analog FM