Clean Water Systems 7500-Rev4 Installation Manual

Clean Water Made Easy
www.cleanwaterstore.com
7500-Rev4 Pro-Ox AIR Filter Installation Guide
Thank you for purchasing a Clean Water System! With proper installation and a
little routine maintenance your system will be providing iron free water for many
years.
Please review this start-up guide entirely before beginning to install your system
and follow the steps outlined for best results.
The Pro-OX Iron Filter media must be activated with a 1 cup of unscented liquid
chlorine bleach (such as Clorox) when first installing it. Read instructions for
more information. It is easy to do, but a critical step.
The Pro-OX media produces very small particles (fines) when the system is first
installed. Bring the water pressure up VERY slowly during the initial backwash by
opening inlet valve slowly to avoid pushing the media up into the control head.
Performing multiple backwashes at start-up is an important step.
You should also not bring any other systems online (i.e. softeners, filters, etc.) until
the Pro-Ox system is fully flushed. Depending on the water quality, this may take
several backwashes and a week or two of normal water use.
The Pro-OX media contains dust. Use paper mask and ventilate area to avoid
breathing dust when first pouring the media into the tank.
Minimum 30 PSI required. Maximum pressure 90 PSI.
For indoor installation. Protect from sunlight, rain, and freezing.
Questions?
Call us toll-free: 1-888-600-5426 or 1-831-462-8500
Email us: support@cleanwaterstore.com
See more information on our website: www.cleanwaterstore.com/resources