Digigram ALP222e-Mic User Manual page 25

User Manual – ALP222e & ALP222e-Mic
From the bottom bar of the I/O Monitor view, select the ALP card to display its Monitor page.
The following table lists the various possible settings from the mixer view.
Click on this icon to display the concerned pair of channels as two mono
channel strips.
Click on this icon to display the concerned pair of channels as one stereo
channel strip.
On a stereo channel strip, the controls (volumes, solo, mute) are applied
to the left and right channels.
Channel strip name
Click on the channel strip name
Note: when a channel strip display is changed from mono to stereo, or
stereo to mono, the channel stream name goes back to the default name.
As a consequence, it is recommended to keep the display mode used
(mono or stereo) when the channel strip names have been changed.
Analog input gain settings
The first screen capture on the left relates to the ALP222e, and the second
one just below relates to the ALP222e-Mic which features a Line/Mic level
selector.
The analog input gain can be adjusted thanks to the potentiometer at the
top of the analog input channel strip. Note that if the inputs are displayed
as a stereo input, the gain adjustment applies to the left and right
channels.
There are three ways of adjusting the input gain.
1) Click on the round potentiometer without releasing and move the
2) Press the Ctrl key without releasing and then click on the
3) Click on the gain value displayed below the potentiometer, write and
Double click on the potentiometer to reset the analog gain to 0 dB.
For ALP222e and ALP222e-Mic in LINE input mode, analog input gain
mouse left or right to decrease and increase the gain respectively, in
steps of 0.5 dB.
potentiometer with the mouse. The gain can be adjusted in steps of 1
dB with the mouse wheel as long as the Ctrl key remains pressed.
enter the new value.
and enter a new name.
25