Digigram ALP222e-Mic User Manual page 16

User Manual – ALP222e & ALP222e-Mic
If the card devices are not listed in the Windows Sound control panel:
Make sure that the card is inserted correctly in the PCI slot and screwed to the computer
●
chassis.
Try to uninstall the ALP-X Kit (from the Windows control panel, Applications) and re-install it.
●
Playback to a device can be tested by right clicking on it and selecting "Test". The VU-meter must
then show modulation and the sound must be heard on the card output(s) according to the
routing and levels configured in the ALP-X Manager application.
If several cards of the same model are installed, their devices have the same name (ALP PLAY
and ALP REC), but the name of the card associated to each device differs from an index (no
index for the first card, and index starting from 2 for the following cards of the same model).
In the example below, the first card in the PCIe slot enumeration order is an ALP222e, the
second card is an ALP222e-Mic, and the third card is an ALP222e.
First card: ALP222e
ALP PLAY 1-2
Digigram ALP222e
ALP PLAY 3-4
Digigram ALP222e
Note
The output WDM device level setting, accessible from the Windows Sound control panel, is
coupled to the corresponding input level setting of the card's onboard mixer, and impacts left
and right channels.
Note that after the first installation of the card, the default gain settings are as follows:
Second card: ALP222e-MIC
ALP PLAY 1-2
Digigram ALP222e-MIC
ALP PLAY 3-4
Digigram ALP222e-MIC
Third card: ALP222e
ALP PLAY 1-2
2-Digigram ALP222e
ALP PLAY 3-4
2-Digigram ALP222e
16