emitor COMBOLOOK Color Manual page 18

Note that 13/18V and 22 kHz on/off may be adjusted while in this mode
with the ”0” and “#” buttons.
3. 3. 3. 3. Span Min Span Min Span Min Span Min – – – – Span Max
This function is covered under the ”Main Menu” section 3 above. This function is covered under the ”Main Menu” section 3 above. This function is covered under the ”Main Menu” section 3 above. This function is covered under the ”Main Menu” section 3 above.
Push button # 3 (Span Min
The instrument zooms in for maximum viewing of the selected frequency
(Span Min = 250 MHz bandwidth).
Another push of # 3 button (Span Max
out”.
4 4 4 4 . Memory . Memory
. Memory . Memory
Memory Positions. Same function as described under Main Menu
section 9, (below).
5. 5. 5. 5. Multi Multi- - - - channel
Multi Multi
Channels (frequencies) that have been memorized under Main Menu
(section 1 and 2) are displayed and measured together with this function.
Up to 10 channels may be measured simultaneously.
Note that all the channels have individualized set-up of the following:
13/18V and 22 kHz on/off.
Multi-channel is useful for ”scanning” a satellite signal, in order to ensure all
parameters are right/max values received on both V/H and low/high.
Pg down Pg down
Pg down Pg down
Pg down Pg down
Pg down Pg down
Max hold Max hold
Max hold Max hold
6. Attenuator: 6. Attenuator: 6. Attenuator: 6. Attenuator:
Attenuation of 15dB. manual on/off with button # 6.
Selected position will be displayed at the right hand side of the monitor.
0. 13/18V: 0. 13/18V:
0. 13/18V: 0. 13/18V:
Sets the LNB voltage to 13V/18V. Selected voltage is displayed in the upper-left of the
LCD-display.
#. 22 kHz #. 22 kHz #. 22 kHz #. 22 kHz
Selection of 22 kHz tone ON/OFF for switching mechanisms. The selected mode is
displayed in the upper-left of the LCD-display.
Span Max Span Max Span Max
Span Min) on the keypad. Span Min Span Min
channel
channel channel
To step down the pages. 10 pages with 10 frequencies per
pagemay be stored (10 analog + 10 digital = 200 frequencies).
To step up the pages.
”Locks” the dB-values and will only change when higher values
are received.
Turn off the function by pressing the button again (no hold).
Span Max) indexes the view back to ”Max zoom Span Max Span Max
18
Main Menu in
Main Menu Main Menu