that will give the user a reference for the concentration of the data-stream.
• Four lock-parameters and a time counter (that shows the lock-time on a bit-
stream) are shown on the right of the CRT display.
When these "lock parameters" are met, the circles on the left of each will fill-in
(become white) and the Lock Timer clock will begin countdown (indicating a
digital transponder lock has occurred with that particular signal).
If no lock occurs, or if the signal fades in and out, the signal is either very poor
and/or weak.
Fine-tune adjustment of the dish may be required and/or check the setting of the
LNB to improve the signal.
• The other measured data such as S/N-ratio (signal/noise ratio) and BER (Bit
Error Rate) are displayed just under the constellation diagram as Bar graphs
(thermometer-scales). The higher level, the better the quality of the signal !
Example of a Locked frequency:
Example of a Locked frequency:
Example of a Locked frequency:
Example of a Locked frequency:
The window also displays the following Digital readout:
Freq:
Freq
Freq
Freq
The frequency that the meters tuned to.
AFC:
AFC
Automatic frequency control -the instrument automatically adjusts the
AFC
AFC
frequency and tells the offset frequency from the center of the carrier.
SR
SR:
Symbol Rate of the signal transmission.
SR
SR
FEC
FEC
FEC
FEC:
Forward Error Correction.
CB:
CB
Corrected Bits Bits that have been corrected in Viterbi.
CB
CB
The Lower the number; the better
UCB
UCB:
UCB
UCB
Uncorrected Blocks Blocks unable to be repaired. Value should be zero.
Even small numbers of uncorrected block will result in loss of picture
(mosaic).
NIT
NIT - - - - Network Information Table.
Network Information Table.
NIT
NIT
Network Information Table.
Network Information Table.
The word "searching" is displayed on right side of the LCD as soon as a
digital transponder is locked. After about 5-10 seconds, if if if if the satellite is
transmitting NIT, the satellite position will appear (and in some cases the
satellite name also), for ex Astra 19.2. Pressing button #4 "Channels" will
show a list of the present TV- and Radio-channels on that specific
transponder/frequency. (See the following diagram)
.
13
Need help?
Do you have a question about the COMBOLOOK Color and is the answer not in the manual?
Questions and answers