Px-32Xsi Internal Drive - Plextor UltraPlex PX-32CSe User Manual

do not plan to use the Eject Lock feature, skip now to Chapter 8, Hardware Installation.
(Take our word for it, most of you can now skip to Chapter 8.)

PX-32XSi Internal Drive

Factory Setting of Jumper Block
The functions shown are ON if the jumpers are installed and OFF if jumpers are
removed. The jumpers are set by the factory as follows:
Pin 3
Pin 2
Pin 1
SCSI-ID
PRTY
TERM
Installing and Removing Jumpers
Ensure power to the drive is OFF before installing or removing jumpers.
To remove a jumper, pull it off with your fingers or a pair of needle-nose pliers.
To add a jumper, push it onto the jumper pins. Three extra jumpers are supplied with the
PX-32XSi in addition to the four jumpers already installed at the factory.
Caution:
Install jumpers across each pin as shown. Do not connect one pin switch
to another by installing the jumpers lengthwise. Doing so could result in
damage to the drive.
Install Jumpers This Way
CHAPTER 6 ---- Drive Switch/Jumper/Dial Settings
ON (Jumper installed)
OFF (Jumper removed)
EJECT
BLOCK
TEST
Jumper
NOT Install Jumpers This Way
Do
ULTRAPLEX OPERATION MANUAL
15